One of Openwrt and IPTV-igmpproxy With IPTV installed, the equipment is a cable modem and an IPTV STB. The former turns HFC into ordinary Ethernet, and …
IPTV service consists of three entities-multicast source, client device and multicast network. This Article will focus on the most frequently asked scenarios of IGMP snooping Multicast network in the Access Layer. And give you the corresponding suggested configuration guide.
Configuration. After successful installation over Pakfire it´s now time to start over. For the use of IPTV it is unfortunately necessary to do some handwork, ...
06.08.2017 · In the IGMP firewall rule for your IPTV_WAN, you need to make sure under "Advanced Options" that "Allow packets with IP options to pass" is ticked. The IGMP Proxy Config requires upstream and downstream configuring: Downstream will just be your multicast IPTV_LAN network, 192.168.4.0/24
19.03.2017 · OPNsense -> Smart switch -> Smart switch -> IPTV The IGMPproxy is configured as following: WAN upstream 83.255.222.0/24, 83.255.216.0/24, 224.0.0.0/4 IPTV downstream 192.168.20.0/24 While running tcpdump -n -i bce0 -e | grep "vlan 20" I can see the igmp reports, and they do show up if I run igmpproxy -d -vvv /usr/local/etc/igmpproxy.conf.
18.01.2019 · The igmpproxy adds routes and rules to the kernel which cause the kernel to forward these multicast UDP packets received on the WAN to the LAN where they are received by the original requester. First you need to install the package opkg install igmpproxy You need to edit /etc/config/igmpproxy according to your setup.
Launch igmpproxy and enjoy IPTV :) igmpproxy /etc/igmpproxy.conf Troubleshooting Make sure your local subnet is not same as your ISP's multicast source. 192.168.0.0/24 is probably safe bet. You might need to add forwarding rules to iptables