srch

I couldn't get WDS working with 21.02.0 and the network/wireless ... (tag: v21.02.0-rc4) OpenWrt v21.02.0-rc4: adjust config defaults ...

Hi all, I am having trouble configuring a wireless link with WDS between 2 of my access points. Everything worked fine with 21.02_rc3 but ...

[FS#3912] [21.02] AP with wds is assigned the wrong vlan OpenWrt Bugs openwrt-bugs at lists.openwrt.org Sun Jul 4 12:33:15 PDT 2021. Previous message (by thread): [FS#3898] Wifi APs are disable when encryption is switched on. Next message (by thread): [FS#3912] [21.02] AP with wds is assigned the wrong vlan Messages sorted by:

@Borromini Thanks again for all the help. I think I have the NETIFD git tree setup and compiling with my openwrt main tree.

04.09.2021 · OpenWrt 21.02.0-rc4 - Fourth Release Candidate - 4 August 2021. The OpenWrt Project is a Linux operating system targeting embedded devices. It is a complete replacement for the vendor-supplied firmware of a wide range of wireless routers and non-network devices. See the Table of Hardware for supported devices. For more information about OpenWrt ...

21.11.2021 · 0, supported in 21.02: Configures data rates based on the coverage cell density. Normal configures basic rates to 6, 12, 24 Mbps if legacy_rates is 0, else to 5.5, 11 Mbps. High configures basic rates to 12, 24 Mbps if legacy_rates is 0, else to the 11 Mbps rate. Very High configures 24 Mbps as the basic rate.

The bug has the following effect: > > I have openwrt 21.02 running on one system running as WDS AP and another > one running as WDS Client.

Jan 15, 2022 · I have a TP-Link Archer C7 v2 running OpenWrt 21.02.0 r16279 which is connected to the internet and is my principle AP. This afternoon I have followed the instructions (both CLI and Luci) to set up a D-Link DIR-835 A1 running OpenWrt 21.02.0 r16325 as a WDS repeater. It does not seem to be working but I do not know how to troubleshoot it. I am confused about the instruction Disconnect the ...

Aug 01, 2021 · OpenWrt v21.02.0-rc4 Changelog. This change log lists all commits done in preparation of OpenWrt 21.02.0-rc4 since OpenWrt 21.02.0-rc3. Commits are roughly grouped by subsystem and chronologically ordered from top to bottom and cover the Git repository history until the tagging of the 21.02.0-rc4 release .

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY. A new Flyspray task has been opened. Details are below. User who did this - ErwanMAS (ErwanMAS) Attached to Project - OpenWrt/LEDE Project Summary - [21.02] AP with wds is assigned the wrong vlan Task Type - Bug Report Category - Base system Status - Unconfirmed Assigned To - Operating System - All Severity - High Priority - Very Low Reported Version ...

The VLAN Konfiguration has changed in OpenWrt 21.02 - Bridge VLAN Filtering and Distributed Switch Architecture (DSA) change the way we configure the ...

Hi there, I have a problem with my wds-connection as well since upgrading my two tl-1043nd_v2 to openwrt 21.02.0 stable.

1 on the access point and the station? I ended up having to restart my openwrt wds station manually after flashing to get it to connect to the ...

Oct 01, 2021 · [FS#3961] Atheros WDS stopped working on TP-Link Archer C60 v2 with OpenWRT 21.02.0 rc4 OpenWrt Bugs openwrt-bugs at lists.openwrt.org Fri Oct 1 10:33:20 PDT 2021. Previous message (by thread): [FS#3955] uboot-lantiq u-boot-2013.10 fails to compile related sha1

15.01.2022 · I have a TP-Link Archer C7 v2 running OpenWrt 21.02.0 r16279 which is connected to the internet and is my principle AP. This afternoon I have followed the instructions (both CLI and Luci) to set up a D-Link DIR-835 A1 running OpenWrt 21.02.0 r16325 as a WDS repeater. It does not seem to be working but I do not know how to troubleshoot it. I am confused about the …

Hi there, I have a problem with my wds-connection as well since upgrading my two tl-1043nd_v2 to openwrt 21.02.0 stable. The connection between ...

04.07.2021 · Attached to Project: OpenWrt/LEDE Project Opened by ErwanMAS - 04.07.2021 Last edited by Kevin 'ldir' Darbyshire-Bryant - 14.08.2021 FS#3912 - [21.02] AP with wds is assigned the wrong vlan I have multiple SID on radio1 BOAT , BEACH-LOC , BEACH-EXT

Nov 21, 2021 · 0, supported in 21.02: Configures data rates based on the coverage cell density. Normal configures basic rates to 6, 12, 24 Mbps if legacy_rates is 0, else to 5.5, 11 Mbps. High configures basic rates to 12, 24 Mbps if legacy_rates is 0, else to the 11 Mbps rate. Very High configures 24 Mbps as the basic rate.

Sep 04, 2021 · OpenWrt 21.02.0-rc4 - Fourth Release Candidate - 4 August 2021. The OpenWrt Project is a Linux operating system targeting embedded devices. It is a complete replacement for the vendor-supplied firmware of a wide range of wireless routers and non-network devices. See the Table of Hardware for supported devices. For more information about OpenWrt ...

Hi all, I am having trouble configuring a wireless link with WDS between 2 of my access points. Everything worked fine with 21.02_rc3 but ...