15.02.2017 · As with most settings in LEDE/OpenWRT, defining your DHCP option is a matter of changing a couple lines in a config file. It is not recommended to manually mess around with these sort of settings…
(I think that applies to stuff happening inside the guest though). In case it matters, my home router is running OpenWrt Chaos Calmer 15.05.1. I'm not sure ...
17.10.2021 · See also: OpenWrt as client device, Router vs switch vs gateway and NAT If your device has some ports labeled LAN and at least a port labeled WAN and you want it to operate as a router (a connection between two different networks). Depending on actual hardware support, it may be possible to create a WAN port on a device with only LAN ports, see your device's page …
31.10.2021 · OpenWrt as client device See also: OpenWrt as router device, Router vs switch vs gateway and NAT, Regaining access to an OpenWrt device in client mode OpenWrt will provide additional functions for the network (for example, you just want to use the Wi-Fi network it provides, or the device is a NAS serving files over the network, or a mini-server offering …
25.03.2019 · If you have set your OpenWrt device to become a network client (e.g. to use it as wifi access point only), you most likely will have purposely turned off DHCP and you will have removed the static IP address from OpenWrt configuration. As a result, the OpenWrt device will no longer be listening to SSH or LuCi/http (or whatever you had used as address range before), rendering …
ISP Configurations This page describes how to connect to networks of different commercial Internet service providers. At this time, most of the DSL configurations described below only apply to modem-router devices using Lantiq SoC. There is no DSL support for Broadcom devices. This article may contain network configuration that is version dependent post 2021-06