by default,openwrt do not allow ssh access from wan, here are two method to change that: 1.login into your wrt from a lan host.issue the following command: iptables -F: the command "flush away" all the firewall rules,including the one that rejects ssh …
16.12.2021 · The rule section is used to define basic accept, drop, or reject rules to allow or restrict access to specific ports or hosts. config rule option name 'Reject LAN to WAN for custom IP' option src 'lan' option src_ip '192.168.1.2' option src_mac '00:11:22:33:44:55' option src_port '80' option dest 'wan' option dest_ip '194.25.2.129' option dest_port '120' option proto 'tcp' option …
03.10.2020 · For secure web access, OpenWrt can be accessed via HTTPS ( TLS) instead of the unencrypted HTTP protocol. If HTTP is not secure enough for you, you can disable the existing (unencrypted) web access and either Tunnel your connection via SSH Follow Providing encryption to set up SSL protected access
30.07.2021 · As services are started on the router, the “total available memory” will go down. In the case of the screenshot, there's lot of memory still available. If the amount is very low, the router could slow down and behave erratically. In that case, one would need to stop and disable services on the router.
25.04.2019 · Dear community I would like to keep my network secure by dropping any connection from internet and stay stealth until i open a port for an OpenVPN connection from the inside. Therefore I would like to create a script to enable/disable external access to call from LAN side. I guess creating a firewall rule and keep OpenVPN server running would be the more secure way …
19.09.2016 · By default, LuCI, the web admin interface for OpenWrt is not HTTPS enabled. This may not be a critical issue for you since it is a LAN facing service, but the type of infrastructure information being exchanged combined with the fact that it is usually accessed over WiFi protocols might make you want to consider it – especially considering it is a 5 minute fix.
15.10.2021 · Optionally, remove or disbable the WAN and WAN6 interfaces. On the Network → Interfaces page, Edit the WAN and WAN6 interfaces to uncheck the Bring up on boot checkbox. Or just delete the interfaces. Note that by default OpenWrt does not enable wireless access.
20.03.2019 · Configuring ulogd2 on OpenWRT to send conntrack events to syslog-ng. My OpenWRT systems already send their syslog to a remote central syslog server. OpenWRT uses logread to send syslogs remotely. The remote server runs on syslog-ng. Therefore I only have to configure ulogd to send the connection tracking events to local syslog instead of a file.
10.11.2021 · Accessing LuCI web interface securely If you are doing admin things via LuCI web interface, there is a risk that a user of your OpenWrt network is sniffing your traffic. You are at risk of giving away your LuCI web credentials to attacker. There are some ways to mitigate this risk.
23.07.2021 · Remove the disable 1 option from the wireless configuration. ... Only proceed with the routed configuration below if you have the ability to reconfigure the remote Access Point! ... There is a router access point (based on openwrt 12.09 final ) and a router wifi client ...