srch

31.12.2021 · docker network create -d macvlan --subnet=192.168.0.0/24 --gateway=192.168.0.1 -o parent=eth0 macnet ps：eth0 为自己实际的网卡名，一般是eth0，看自己ssh连接的ip网卡名就行 注意：macnet 为名称，macvlan 为模式，另外请将 192.168.0 修改为你自己主路由网段。

22.09.2021 · Docker macvlan network on OpenWRT x86. Hi, I’m trying to use OpenWRT x86/64 as a Docker host to run pihole attached to the LAN network of OpenWRT. I have done this before with an Ubuntu host where pihole is a docker container, running on the Ubuntu host connected to bridged Ethernet network. I had to do the macvlan workaround so that the ...

10.01.2019 · docker 中运行 openwrt [toc] 思路 利用 macvlan 方式创建虚拟接口进行配置。 有感于来自恩山 betterman 及 rightwifi2017 两位大佬斐讯 N1 的玩法，也获得两位大佬的帮助，在此感谢两位大佬。 由于 N1 为单网卡，所以配置只能为单臂路由，本案为双网卡 opewnrt 机器拥有双网卡: enp1s0 及 enp3s0 ，本案将 enp3s0 用作 ...

Raspberry Pi powered via Power over Ethernet running OpenWRT; Using its single ... opkg install dockerd docker-compose luci-app-dockerman kmod-macvlan.

28.03.2021 · OpenWRT can be installed on physical machine, virtual machines, also docker environment. This post summarizes some steps how to get OpenWRT running into your docker environment. Docker Image : sulinggg/openwrt:latest https://ift.tt/39lTyxE Topology Create macvlan Network Create macvlan configuration : Create macvlan network: Command line: …

Multiple macvlans with VLANs configuration. Docker Macvlan Bridge on VLAN 802.1Q trunk. You have a Docker host with a single eth0 interface connected to a ...

Hi, I'm trying to use OpenWRT x86/64 as a Docker host to run pihole attached to the LAN network of OpenWRT. I have done this before with an ...

Create macvlan configuration : Create macvlan network: Command line: docker network create -d macvlan --subnet=192.168.2.0/24 --gateway=192.168.2.1 -o parent=wlan0 macnet. Check the network created for Docker environment: root@ubuntu:/etc# docker network ls NETWORK ID NAME DRIVER SCOPE 0f5799ba3db3 bridge bridge local ad41a2fa3a8a host host ...

I'm trying to move my pihole docker container from my standalone rpi to my OpenWRT router - currently running on a small x86 embedded PC.

Add the following lines to /etc/config/network to setup the interface and routing stuff on openwrt. To get the need interfaces and routing ...

Create macvlan configuration : Create macvlan network: Command line: docker network create -d macvlan --subnet=192.168.2.0/24 ...

I'm trying to use OpenWRT as a Docker host to run pihole attached the LAN network of OpenWRT. I have done this before with an Ubuntu host ...