mirror of git://git.openwrt.org/openwrt/openwrt.git ... This commit introduces firewall4, an nftables based reimplementation of the UCI iptables firewall.
16.12.2021 · Name Type Required Default Description ; name: forward name : no (none) Unique forwarding name. src: zone name : yes (none) Specifies the traffic source zone.Refers to one of the defined zone names.For typical port forwards this usually is 'wan'.
Netfilter In OpenWrt The purpose of this section is to briefly describe the netfilter/iptables subsystem and then delve into OpenWrt specifics. netfilter rules require a fine level of granularity to tune packet filtering. This can cause undesirable scenarios when many rules are matching on similar packets. Be careful using the iptable application!
The OpenWrt firewall implementation is the mechanism by which network traffic is filtered coming through the router. At a high level, one of three outcomes will occur: either the packet is discarded (dropped) without any further action, rejected (with an appropriate response to the source), or accepted (routed to the destination).
08.11.2013 · OpenWRT is an active and vibrant home firewall project that was born on the Linksys WRT54G line of home routers. It has grown and expanded to support an amazing array of old and new hardware alike. The list of compatible hardware is large enough to require its own index.. With the recent interest in the Raspberry Pi there is of course is an OpenWRT build for it as well.
15.10.2021 · Summary: This document describes how to create and add a wireless access point (AP), sometimes called a dumb AP, to an existing network with a single main router.The term dumb is used since the router provides no routing, DHCP or DNS services. Instead, those services are provided by the main router. One of the most common reasons to do this is to add additional wifi …
06.12.2019 · Recommended firewall settings. darksky October 25, 2017, 5:15pm #1. If you pull up Network>Firewall what are the recommended settings for "General" and "Zones?" Upon reading google hits, many are showing a "Lan -> wan" setting of "reject" for forward whereas the out-of-the-box settings have that set to "accept" including this OpenWRT wiki.
for the next OpenWrt release firewall4 is considered as a replacement of the current iptables based firewall package. While the configuration stays within ...