[OpenWrt Wiki] DDNS client configuration
openwrt.org › docs › guide-userSep 06, 2021 · Checks below 5 minutes make no sense, because the DNS Servers in Internet needs about 5 minutes to sync. either both options are set or not set. check_unit: string : no 'minutes' force_interval: number : no '72' Force to send an update to service provider, if no IP change was detected. Consult DDNS providers documentation, if your DDNS entry ...
[OpenWrt Wiki] DDNS client
https://openwrt.org/docs/guide-user/services/ddns/client23.10.2021 · OpenWrt uses ddns-scripts which are shell scripts. There are other scripts and programs available in the web, also some DDNS providers offer their own programs. All of them are currently not ported and tested on OpenWrt. Features ddns-scripts support other special communication functions: Run once, useful for usage with cron.
[OpenWrt Wiki] DNS and DHCP configuration /etc/config/dhcp
openwrt.org › docs › guide-userDec 16, 2021 · OpenWRT interface name (NOT network device name) where the destination DHCP server is located. local_addr: string : yes (none) This OpenWRT device's own IP address on the far subnet, where it will listen for DHCP requests. server_addr: string : yes (none) IP address of the upstream DHCP server accessible through the network given by the ...
[OpenWrt Wiki] DoH with Dnsmasq and https-dns-proxy
openwrt.org › docs › guide-userDec 05, 2021 · DoH with Dnsmasq and https-dns-proxy This article relies on the following: * Accessing OpenWrt CLI * Managing configurations * Managing packages * Managing services Introduction * This how-to describes the method for setting up DNS over HTTPS on OpenWrt. * It relies on Dnsmasq and https-dns-proxy for masking DNS traffic as HTTPS traffic. * Follow
[OpenWrt Wiki] DDNS client
openwrt.org › docs › guide-userOct 23, 2021 · Configure Bind. The first step is to set up bind to allow updates to the A ( IPv4) and AAAA ( IPv6) records for openwrt.example.org. To do this, log onto your DNS server and run /usr/sbin/ddns-confgen -s openwrt.example.org. This will generate the key and shared secret that will be used to update DNS.