srch

Looking at LEDE's table of hardware, there are a few VDSL2 devices which should support OpenWrt/LEDE, but for all of these devices when I look ...

afaik there is no good option to have a voip -> dect/pots/isdn with openwrt. also devices with vdsl-modem tend to have weak performance w/o ...

30.08.2019 · xDSL (Digital subscriber line) Note: This page is for hardware and driver; for help configuring your Internet connection, please see Configuration of the Internet connection See the other internet.access.technologies. Overview There are at least three companies with xDSL-Solutions: Wikipedia Documentation in OpenWrt Wiki

So got openwrt on there and found a vdsl firmware bin for my connection and loaded all the settings in, this is where I'm stuck, ...

A couple years ago, I flashed OpenWRT onto my Linksys WRT32X router and it's been working great since then. Recently, I bought some new networking hardware, including a new router. I want to set up this WRT32X as a "dumb AP" with multiple SSIDs, with each SSID belonging to …

For all intents and purposes, "OpenWrt-supported VDSL2+ modem" means that the device is based on a chipset in the Lantiq VRX200 "VR9" family.

Hi I am searching for an ADSL/VDSL capable modem or modem+router ... of OpenWRT firmware by myself) and can wait for the fully open VDSL ...

EDPnet provides VDSL services through PPPoE and VLAN tagging. Keep in mind the DSL state monopolist (Proximus) still manages the backbone and keeps a ...

NETGEAR DM200 ADSL / VDSL2 Modem Router based on Lantiq VRX220 SoC. Key features: * Works out-of-the-box with OpenWrt, including the ADSL/VDSL2 modem! * Easy to flash with OpenWrt with vendor's web interface. * 1x 10/100 wired Ethernet interface. * No WiFi, no USB.

Hi All I'm trying to work out how to set up a BT Home Hub 5 with OpenWrt to work with my RJ11 connections I've seen masses of instructions for help with a ...

2 dager siden · OpenWrt support for FiberHome VDSL2 modem HG150-Ub. MMZF December 28, 2021, 8:18pm #1. I have a FiberHome Vdsl2 modem model: HG150-Ub, i was wondering if i can find openwrt for it. i would love to use it as a router (range extender if possible via ethernet or wireless). This is the picture of it from inside i hope somebody could understand its ...

01.11.2021 · ISP Configurations This page describes how to connect to networks of different commercial Internet service providers. At this time, most of the DSL configurations described below only apply to modem-router devices using Lantiq SoC. There is no DSL support for Broadcom devices. This article may contain network configuration that is version dependent …

There are some routers that support vectoring and are been supported by lede/openwrt. Check the XRX200 chipsets devices from lantiq. A device that have those build in are like written here few times the TD-W8970, TD-W8980 and the TD-W9980 in those first hardware revision.

59 rader · 09.11.2019 · Table of Hardware: DSL Modem supported This page shows devices …

vdsl-router. This repository contains my very personal DSL router configuration based on OpenWrt on a TP-Link TL-WDR4900 and the VDSL modem DrayTek Vigor ...

I'm looking for a VDSL2 modem (or a modem+router which I can use as a modem) which supports OpenWrt/LEDE. Looking at LEDE's table of hardware, there are a few VDSL2 devices which should support OpenWrt/LEDE, but for all of these devices when I look at forum posts it seems like nobody actually managed to get OpenWrt/LEDE running properly.

02.05.2020 · The lantiq SOC family is the only xDSL capable SOC that is fully supported by OpenWrt, for the vr9 (VRX268/ VRX288) generation (do yourself a favour, don't even think about the older generations (their blob state is roughly equivalent and the hardware much worse) - and the newer ones aren't supported yet), this covers all variants of ADSL and VDSL/ VDSL2 without …

I'm looking for a VDSL router for a 50 Mbps DSL connection (Germany). ... matter for VDSL) would be https://openwrt.org/toh/bt/homehub_v5a, ...