GitHub - SXRISTAKIS/Pluto-SDR
github.com › SXRISTAKIS › Pluto-SDRMar 14, 2022 · Go under [ETHERNET] and change the ipaddr_eth to the desired IP. Caution: the IP must belong to the subnet of the LAN. (In my case the LAN uses 10.64.45.45 subnet and the IP I gave Pluto is 10.64.45.45) Then, save the configured file and eject (not unplug) the PlutoSDR device from your host. Wait for 5 seconds Finally unplug the SDR device and ...
GitHub - unixpunk/PlutoWeb: PlutoWeb
https://github.com/unixpunk/PlutoWeb14.05.2019 · There are 2 ways to flash the PlutoSDR the first is: First put the boot.frm on the mass storage and eject it, then wait. Once its done and back up, put the pluto.frm on the mass storage and eject it. Then it should boot, reboot once and be ready to go. If using USB, just enter the 192.168.2.1 IP into your browser.