15.06.2016 · 15 Jun 2016, 08:36. @Brains said in Ubiquiti Support - Firewall Exceptions For Controller To Allow Firmware Updates: We have only upgraded the firmware through the controller once so far and did this: Yes, that is how you upgrade an AP from inside the controller. To get newer firmware, you have to update the controller.
In each video, when setting the Guest account up, the presenter goes to Settings -> Routing and Firewall -> Firewall. In each tab, there are a number of rules ...
09.01.2018 · Setting up an Unifi Controller is really and can be done in a couple of minutes with this beginner’s guide. We are going to walk through the initial setup of the controller, connecting the access points and getting the most performance out of it.
02.05.2019 · @xman111 said in Problems with Unifi AP and firewall rules: Hey guys just setting up a Unifi AP at my parents house. I have a quad port NIC and have their main network at 192.168.1.0/24 and their Unifi on it's own at 192.168.2.0/24. I manage the AP from a computer on the 192.168.1 network so they are on different subnets.
Responses (2) · unifi.http.port=8080 (port for UAP to inform controller) · unifi.https.port=8443 (port for controller GUI / API, as seen in web browser) · portal.
What Controller version and firmware are you using? Do you use new settings or old settings? I separate inter vlan traffic with such example rule: LAN IN. Name: drop STATE_NAME VLAN_NAME to VLAN_NAME sessions (drop all IoT to LAN sessions) enabled. Rule applied: before predefined rules. Action: drop. Protocol: all. Source type: network ...
11.10.2019 · Configuring Site Settings. Head over to your Ubiquiti UniFi Network Controller in the web browser and on the left hand side go to “Settings” at the bottom. Under settings if you’re not there already go ahead and click “Site”. A …
Our unifi controller is installed on a Windows 7 machine, at the moment I have disabled the firewall on the Windows 7 and also configured our network ...
Note: Although TCP 22 is not one of the ports UniFi Network operates on by default, it is worth mentioning in this article since it is the port used when UniFi devices or the Network application is accessed via SSH. Ingress Ports required for L3 management over the internet. Note: These ports need to be open at the gateway/firewall as well as on the UniFi Network application host.
03.07.2019 · UniFi Setup from Scratch Part 3 – Setting Up VLANs and Firewall Rules July 3, 2019 admin 16d Comments Today on the hookup I’m going to show you how to create the most secure smart home network possible by creating VLANs and firewall rules to separate your IoT and NoT devices from the rest of your network.
12.06.2020 · In this video I show you how to create firewall rules to block inter-vlan communication on the Unifi dream machin pro ( you can do this on the UDM, USG and U...
My setup is a cable modem. with router functionality and behind that one is my USG and my AP-AC-Lite, in the cable. modem i managed to forward the ports to ...
We have firewall rules in place on our Windows Firewall to allow traffic for AP/controller ... You should also review the Unifi Controller Firewall rules.
After a bit of troubleshooting I think I narrowed it down to the Windows Firewall because if I turn it off the controller can communicate with the devices no problem. If I turn it on, I can't access the devices. So, I created a couple rules: UDP and TCP and opened all the ports on all the profiles for all interfaces but that didn't work.