Dec 21, 2016 · Hey, I have been using LEDE on my netgear r8000 for a little bit and just today beginning around 5:30 or so, when trying to use the opkg update command it gives me wget returned 4. Is there some rearranging of the site or something? I am curious because I have not been able to set-up the web interface to turn on wireless, but ethernet is fine. Hope I make sense.
Aug 12, 2016 · 08-12-2016 06:21:26. For connecting the internet on VM , you have to be in Brigde Network. 1) Check are you able to ping the host from vm ware, reverse dns should be enabled. 1) look at default gateway. 3) update same ip address for the gateway , use "wget" once work is done ,you can switch to NAT.
01.02.2015 · Solved: Hi everyone, I am trying to use Alex's repo on my 2nd Edison. On my first edison, it worked like a beauty but my 2nd Edison is giving me
Mar 18, 2021 · This “famous” wget 4 error in opkg is just a general error from wget that says that your network settings are wrong, see wget manual. It has almost nothing to do with opkg itself. Some people report that wget may give this response if it attempts to use IPv6 and fails.
"wget returned 4" during opkg update ; Make sure there are no soft blocks. ~# rfkill list ; Make sure wlan0 is loaded and see IP. ~# ifconfig ; Load the wlan0 ...
18.03.2021 · This “famous” wget 4 error in opkg is just a general error from wget that says that your network settings are wrong, see wget manual. It has almost nothing to do with opkg itself. Some people report that wget may give this response if it attempts to use IPv6 and fails.
12.08.2016 · 08-12-2016 06:21:26. For connecting the internet on VM , you have to be in Brigde Network. 1) Check are you able to ping the host from vm ware, reverse dns should be enabled. 1) look at default gateway. 3) update same ip address for the gateway , use "wget" once work is done ,you can switch to NAT.
Nov 23, 2016 · If you're asking for the contents of the resource that wget received, then you need to instruct wget to send its output to stdout instead of a file. Depending on your flavor of wget, it's likely an option like -O or --output-document, and you can construct your command line as: wget -O - <url>. By convention the single dash ( -) represents ...
06.09.2020 · Hey, I have been using LEDE on my netgear r8000 for a little bit and just today beginning around 5:30 or so, when trying to use the opkg update command it gives me wget returned 4. Is there some rearranging of the site or something? I am curious because I have not been able to set-up the web interface to turn on wireless, but ethernet is fine. Hope I make sense.
Feb 01, 2015 · Solved: Hi everyone, I am trying to use Alex's repo on my 2nd Edison. On my first edison, it worked like a beauty but my 2nd Edison is giving me