Device is not active" and radio1: "Generic 802.11bgn. Device is not active" Although I can scan both card and I can get result existing wifi networks. On the router both wifi LED is light but not blinking. with the original tplink firmware both wifi is working so I think this not a hardware failure. here is my /etc/config/wireless:
15.01.2020 · OpenWrt 19.03 - Steps to reproduce Freshly installed. Reboot/Restart do not fix the issue Radio0 is a Generic 802.11bg device, which is always not active even after restart of the device, or reboot of the router. There is a Radio2, which is a Generic 802.11bgn device, which is working normally for 2.4Ghz band.
08.03.2020 · luci says my wifi "Device is not active" yet it scans from the command line Linux OpenWrt 4.19.101 #0 SMP Thu Feb 13 20:35:13 2020 aarch64 GNU/Linux snapshot for Raspberry Pi 4 using built in wifi: [ 7.815552] brcmfmac: brcmf_c_preinit_d...
Radio0 Device is not active (2.4g band) - Device problem occurs on XIAOMI 3G - Software versions of OpenWrt 19,07 Go closed ticket FS#2737 - Radio0 Device is not active (for history) . Hi, i make reset all WIFI config, same problem on radio0 not starting
07.02.2021 · OpenWRT 19.07.6, Archer C7 V5. In LuCI, both radios are showing as not active. One is a 2.4ghz, the other is a 5ghz. radio0 - Generic 802.11bg Device is not active radio1 - Generic 802.11bg Device is not active here …
23.02.2021 · Installing and troubleshooting USB Drivers * A Quick Start for installing a USB drive is available. This solves the very common case of installing a single USB drive onto your OpenWrt device. * If the Quick Start doesn't address your question, you can install USB drivers manually. Background information about the different USB host controller interfaces (OHCI, UHCO, EHCI) …