removing dnsmasq before installing dnsmasq-full will make it impossible to download packages. Also the dns-resolver failed to work on my router afterwards. This line works for me: opkg install dnsmasq-full --download-only && opkg remove dnsmasq && opkg install dnsmasq-full - …
removing dnsmasq before installing dnsmasq-full will make it impossible to download packages. Also the dns-resolver failed to work on my router afterwards.
FS#1765 - dnsmasq-full fails to listen on dhcp socket after reboot. When I restart my router, dnsmasq comes up and works for IPv6, but fails to serve out dhcp for ipv4. Supply the following if possible: - Device problem occurs on. Ubiquiti Edgerouter Lite. - Software versions of OpenWrt/LEDE release, packages, etc.
14.02.2021 · dnsmasq-full Version: 2.80-1.4 Description: It is intended to provide coupled DNS and DHCP service to a LAN.\\ \\ This is a fully configurable variant with DHCPv4, DHCPv6, DNSSEC, Authoritative DNS\\ and IPset, Conntrack support & NO_ID enabled by default.\\ \\ Installed size: 153kB Dependencies:
17.02.2021 · Dnsmasq supports static and dynamic DHCP leases and BOOTP for network booting of disk-less machines. It is already installed and preconfigured on OpenWrt. Configuration The configuration is done with help of the uci-configuration file: /etc/config/dhcp, but you can use this together with the file /etc/dnsmasq.conf .
27.02.2018 · FS#1265 - dnsmasq-full breaks dnsmasq on install. Apologize in advance if Critical is not the correct severity for a package needed to make dnssec work. I’ve used dnssec mostly successfully with dnscrypt-proxy & dnsmasq-full on Choas Calmer. I recently upgraded to LEDE & the dnsmasq-full package fails to start dnsmasq for some reason.