srch

31.03.2018 · If you want to contribute to the OpenWrt wiki, please post HERE in the forum or ask on IRC for access. Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

03.04.2019 · A VLAN is a logical broadcast domain in an ethernet network and its switches. The real equivalent in software is a (set of) linux bridge group (s), but not an ethX.Y. I suggest to replace the term driver-level-vlan with sub-interfaces (of ethX).

... from 1 LAN (on eth0) to a trunked driver-level VLAN solution, where all … ... Current setup: openwrt eth0 attached to cascade of cheap ...

Hi! I'm having difficulty figuring out what is the difference between a software vlan (driver-level vlan) and a hardware vlan. I read the…

FS#1622 - DSA switch port vlan. Device: Turris Omnia. Version: OpenWRT-18.06-rc1. Steps to reproduce: Network configuration: config interface 'lan' option type 'bridge' option ifname 'lan0 lan1 lan2 lan3 lan4.1' option proto 'static' option ipaddr '192.168.1.1' option netmask '255.255.255.0' config interface 'dmz' option type 'bridge' option ...

I have setup a driver level vlan, I am using a 8devices Jalapeno as my router. The config I have is: config interface 'lan10' option type ...

I am a little bit lost how to configure a VLAN on DIR-882 (there is vlan support bot no switch). I think i need to create driver-level VLANs ...

Hello, All I have a TPLink RE450 v2 with OpenWRT installed (snapshot) I believe. It has a single physical ethernet port.

Hi, I'm trying to understand the VLAN inplementation on OpenWrt/LEDE. I have LEDE "Reboot (17.01.4, ... Creating driver-level VLANs".

Are there any known bugs/issues with swconfig or the AR7240/AR9330 OpenWrt switch driver that could be causing this? (None came up in my searches.).

27.08.2018 · Welcome back to Project Overkill. This instalment covers, as suggested by the title, configuring OpenWRT 18.06.1 to support 802.1q VLANs on a TP-Link TL-WR810N. There are two pre-requisites: the network chipset in the router must support VLANs (some don't), and OpenWRT's configuration files must contain some instructions defining the switch and …

在 OpenWRT 上架設 VLAN 在 OpenWRT 上針對有線網路設定 VLAN VLAN 的介紹 除了 OVS 之外，另一個常用的網路虛擬化稱為 VLAN (Virtual Local Area Network)，顧名思義，VLAN 的主要功能就是組件一個虛擬的 LAN，換句話說，所有廣播的封包，都會被限制於同一個 VLAN 裡面，在其他 VLAN 則無法得知廣播的訊息。 透過適當的 VLAN 設計，一方面可以增加網路的安全性，另一方 …

Is there a way in LuCI to create a driver level VLAN as explained at ... ://openwrt.org/docs/guide-user/network/vlan/switch_configuration ...

The CPU uses driver level VLAN -management for this, as it acts as a single-port device. Note how the WAN and LAN VLAN ...

Can't get VLAN to work. I've got one OpenWrt device acting as router/firewall (a PC Engines apu2) and two OpenWrt devices acting as AP (Gl-Inet 1300). I want a separate WIFI ssid for guests, which shouldn't have access to the LAN, only to the internet. My plan was to use a vlan for the guest network. So what i did was to add a new network ...

What is the difference (if any) between using Bridge VLAN filter/DSA to setup VLAN tagging and creating a driver-level VLAN in the context ...

05.11.2021 · OpenWrt supports IEEE 802.1Q and IEEE 802.1ad VLAN standards. Many embedded devices with more than 1 port contain a VLAN -capable switch (all routers with a WAN port have a VLAN -capable switch for example).

29.08.2021 · Linksys WRT3200ACM The WRT3200ACM is part of the wrt_ac_series, with 4 detachable antennas, and a faster dual core processor. It is a dualband, 802.11ac wave 2 (160MHz, no 80+80) capable device. While only 1 revision of the hardware is listed, silently (around Nov 2017) the flash chip was updated in production causing earlier firmwares to be …

Hi! I'm having difficulty figuring out what is the difference between a software vlan (driver-level vlan) and a hardware vlan. I read the but I'm …