09.03.2016 · PuTTY If you are connecting via terminal, then just SSH to your LEDE/OpenWRT device using the following command, where 192.168.1.1 is your LEDE/OpenWRT device’s IP address. ssh root@192.168.1.1...
07.02.2015 · Change the VLAN ID for the new VLAN Interface to 823. With your Astro IPTV decoder plugged into your router’s Port 4, it should be then Port 5 in the OpenWRT Switch interface. Under VLAN ID 823, ensure that CPU, Port 1 both are “Tagged”. For Port 5, set it as “Untagged”. Rest set as Off. Under VLAN ID 1, turn off the tagging for Port 5.
01.06.2021 · OpenWRT 21.02.0-rc2 Vlans for TM-UniFi Home. Finally, the much-waited LuCI for Vlan-ing tag/untag on the current latest OpenWRT 21.02.0-rc2 release. Managed to get UniFi-home both vlan.500 (PPPoE internet) and vlan.600 (IPTV) working, but .... Noticed this 21.02.0-rc2 just baked from oven yesterday, so quickly pulled out some toys to test around vlan-ing …
27.12.2021 · Hi! I've been using a TP-Link WDR4300 as my router for many years and IPTV with VLAN has been working fine. Now I've upgraded to an APU2 board and can't figure out how the configuration should look like to make the IPTV traffic go further downstream in my LAN. IPTV VLAN interface gets an IP from provider like before but that's it. Because the TV itself is in …
05.11.2021 · To use a VLAN you need at least 2 devices supporting VLAN features (as any route requires at least 2 points), which is usually advanced routers, any OpenWrt device, and any self-respecting PC or single-board computer (Windows, MacOS, Linux and BSDs support VLANs). OpenWrt supports IEEE 802.1Q and IEEE 802.1ad VLAN standards.
23.03.2016 · Hello, at first - sorry for my bad english. My ISP provides internet connection on VLAN 999 and IPTV on VLAN 11. I have router TP-Link WDR4300 with last version of OpenWRT and STB, which does not support VLANs.
01.11.2021 · Place the supplied Telstra modem into bridge mode, and plug an openwrt router into one of the LANports. No special settings need to be applied, just DHCP. The Telstra modem will do the authentication for you. Note: It may be useful to assign a static IPto the OpenWrt router from the modem, and optionally place it into a DMZ TPG (HFC)