07.06.2018 · Wenn ein Host UDP-Multicast-Pakete empfangen will, muss dieser der sogenannten “UDP-Multicast-Gruppe” beitreten.Genau das wird durch das IGMP-Protokoll definiert. Wenn ein Host dieser Gruppe beigetreten ist, wird der gesamte Netzwerkverkehr durch broadcast L2 frames an diese Gruppe gesendet. Dieses Detail ist wichtig, denn gewöhnliche Netzwerkbrücken geben …
04.01.2013 · I thought I could use IGMP Snooping for this, since I found a comment "starting from 2.6.34, the kernel has IGMP snooping feature for the software bridges (disabled by default in OpenWrt)" and my kernel is 3.6.11 running r34761, but I can't find anywhere that explains how to turn this feature on.
18.01.2019 · In the usual scenario, LAN clients such as smart TVs wish to receive multicast streams from an ISP IPTV service operating on IPv4.Since the LAN clients are behind the OpenWrt router they can not simply send an IGMP request and start receiving the relevant TV data as only other machines on the LAN will hear the IGMP request. Instead the OpenWrt router must act as …
Multicast problem: UAP-AC 3.2.5: Works fine in OpenWRT Barrier Breaker ... I have a UAP-AC v1 connected to the POE injector supplied with the device. I'm ...
17.01.2019 · hello, i finally got igmpproxy installed and my router settings are set to default. What settings need to be changed to allow multicast from WAN to LAN ? I read many posts on this topic but I can't get it to work. Please help. PC1(10.0.0.50) sends multicast stream (239.1.1.1:1234) to a switch and PC2 is connected over LAN to my router (192.168.1.1). Then I …
Effective use of multicast technology can significantly reduce network load, especially in ... Performance of IGMP Protocol on Embedded Systems with OpenWRT.
19.12.2021 · If you want to contribute to the OpenWrt wiki, please post HERE in the forum or ask on IRC for access. Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Network basics /etc/config/network This article may contain network configuration that is version dependent post 2021-06 * ifname@interface has been moved to device and device sections * while legacy ifname syntax may work on 21.02 or recent master it is recommended that you migrate to device usage
I got a new Linksys WRT3200ACM and installed OpenWRT 21.02.0-rc2 on it. This works OK for a short while, but with WiFi usage, pretty quickly I see: Sat Jun 12 17:37:02 2021 kern.err kernel: [ 847.050436] ieee80211 phy0: cmd 0x801d=MEMAddrAccess timed out Sat Jun 12 17:37:02 2021 kern.err kernel: [ 847.056304] ieee80211 phy0: return code: 0x001d ...