15.11.2021 · Configure your router To complete the OpenWrt configuration, open the router's Network → Interfaces page in a separate tab or window, find the WAN6 interface, and click Edit: Change Protocol to IPv6-in-IPv4 (RFC4213) Click Change Protocol and confirm. You'll see the WAN6 Common Configuration page (image below).
27.11.2021 · OpenWrt uses a source-address and source-interface based policy-routing system. This is required to correctly handle different uplink interfaces. Each delegated prefix is added with an unreachable route to avoid IPv6-routing loops. To determine the current status of routes you can consult the information provided by ifstatus. Example (ifstatus ...
ISP Configurations This page describes how to connect to networks of different commercial Internet service providers. At this time, most of the DSL configurations described below only apply to modem-router devices using Lantiq SoC. There is no DSL support for Broadcom devices. This article may contain network configuration that is version dependent post 2021-06
25.11.2018 · To fix this, we’ll add WAN6 to a new firewall zone: And configure the zone in this way: To test the setup you’ll need either a VPS with IPV6 enabled or use online tools like this one. Once done with the firewall, IPv6 address of the router will be directly accessible from outside, but none of the computers on our internal network. On the ...
Assuming your tunnel interface is called wan6, add the following sections to /etc/config/firewall to create a new zone wan6 . config zone option name 'wan6' option network 'wan6' option family 'ipv6' option input 'ACCEPT' option output 'ACCEPT' option forward 'REJECT' config forwarding option dest 'wan6' option src 'lan'
Why is there a “WAN” and a “WAN6” and a “LAN” interface in OpenWrt, but no “LAN6” ? Note that there is a “ WAN ” and “WAN6” interface. Each of the 2 WAN interfaces holds config data related to the upstream interface ( WAN is for IPv4 and has “ DHCP client”, while WAN6 is for IPv6 has “DHCPv6 client”).
08.08.2018 · WAN6 is only an alias to get an IPv6 address from the same interface. If you look at your configs, you'll see there isn't a way to add credentials. The config only says "@wan" and should use DHCPv6 to get an IP. munch May 8, 2018, 8:53pm #5 Router WAN connected to Fibre router in bridge mode Router LAN port 1 VLAN1 connected to internal network