srch

It may have a setting for delegating an IPv6 prefix to your OpenWrt device. If enabled on the upstream router OpenWrt should be able to configure a global IPv6 prefix on LAN automatically. If the upstream router doesn't support prefix delegation then you can instead try the IPv6 relay configuration in OpenWrt as a workaround. 3

My Setup: Internet -> WAN (LTE-Modem) -> Router -> LAN (Clients) My router got a global unicast address for his wan-side (2a01:598[...]/64).

No ipv6 on LAN devices, general uncertainty · Installing and Using OpenWrt Network and Wireless Configuration · likeliterally June 22, 2021, ...

I'm trying to disable ipv6 on my LAN, and seem to be stumbling. I initially just set to disabled in LUCI for both my WAN and LAN interface, ...

Hi, I installed OpenWRT on a Netgear R6120 and configuring IPv6 ... At first I had no IPv6 default route from LAN, until I had set the ...

Self-registration in the wiki has been disabled. If you want to contribute to the OpenWrt wiki, please post HERE in the forum or ask on IRC for ...

27.11.2021 · IPv6 configuration See also: Routing example: IPv6, IPv4/IPv6 transitioning The default firmware provides full IPv6 support with a DHCPv6 client (odhcp6c), an RA & DHCPv6 Server (odhcpd) and a IPv6 firewall (ip6tables). Also, the default installation of the web interface includes the package luci-proto-ipv6

2 dager siden · IPv6 working from WiFi, but not wired LAN. I am using OpenWrt 21.02.1 r16325-88151b8303 / LuCI openwrt-21.02 branch git-21.295.67054-13df80d on a BT Home Hub 5A. (I purchased this device through eBay with OpenWrt pre-installled). I used this to replace a Zyxel DSL Router. Previously, IPv6 was working fine, but with the switch to OpenWrt, ipv6 ...

On that setup LAN is getting the first /64 and WLAN is getting the 2nd /64. IPv6 from the LAN is working great while IPv6 from the WLAN does not work. I've tested this on Mac OS X and Linux and both are unable to get out over WLAN but are able over LAN (I've confirmed they're getting new IPs from the correct pool when I change devices).

I have 4 dumb APs (OpenWRT) and 1 router (FTTH force me to use it - no OpenWRT). The router have RA and DHCPv6 enabled (default ...

The short-term workaround is to have OpenWrt not advertise a ULA prefix. You can go to Network > Interfaces, blank out the IPv6 ULA-Prefix box, ...

I use the following settings, but still get ipv6 address on lan interface: uci set 'network.lan.ipv6=off' uci set 'dhcp.lan.dhcpv6=disabled' ...

25.11.2018 · To test the setup you’ll need either a VPS with IPV6 enabled or use online tools like this one. Once done with the firewall, IPv6 address of the router will be directly accessible from outside, but none of the computers on our internal network. On the other hand, all computers inside our network will be able to use IPv6 sites with no problems.

But the LAN interface is getting an address that starts with f and the clients connected to it have no IPv6 internet connectivity.

hello and thanks, i want to disable all ipv6 functionality, on wan and lan, dhcp, dns? i found this suggestion, will this do it, ...