10.12.2021 · The rescan job runs upon schedule defined individually for every protection group in the protection group settings. By default, Veeam Backup & Replication is set up to perform discovery at 9:00 PM daily. You can adjust daily schedule in the protection group settings or define periodic schedule. The rescan job itself is not displayed in the ...
[For NAS, Veeam Agent integration] General infrastructure. Receiving storage system information. Defining the storage system data hierarchy (volumes, ...
Rescan (Storage Discovery) Process · Open the Storage Infrastructure view. · In the inventory pane, expand the storage system tree. · Select a node in the storage ...
10.09.2021 · Veeam Support Knowledge Base answer to: Rescan fails with "Unable to install backup agent: cannot connect to Error: Known agent have the same bios uuid but different connection point ."
19.10.2021 · During the rescan operation, Veeam Backup & Replication performs full data synchronization between an AHV Backup Proxy and Veeam Backup & Replication. Rescan will erase and re-download AHV Backup Proxy settings and statistics. To rescan an AHV Backup Proxy, do the following: Open the Backup Infrastructure view.
07.03.2016 · yesterday I had to restore the Veeam-Backupserver. I did a fresh install and restored the configuration. The last message during the restore was to wait for some tasks to finish before reactivating the Backupjobs. In the Job-History under "System" I can see two tasks - "Shell run" and "Infrastructure rescan" - they started yesterday at 20:00 ...
26.08.2020 · You can rescan a selected tape library or standalone tape drive to update its network status. To rescan a tape device: Open the Tape Infrastructure view.; Select the Libraries node in the inventory pane.; Select a necessary item in the working area and click Rescan Library on the ribbon. You can also right-click the necessary device in the working area and select Rescan.
18.02.2021 · Veeam Backup & Replication automatically performs a rescan operation every 4 hours. You can also start the rescan operation manually: Open the Backup Infrastructure view. In the inventory pane, select Managed servers. In the working area, select the server or host and click Rescan on the ribbon. Alternatively, you can right-click the server or ...