srch

With IGMP snooping enabled, by default multicast doesn't go out any port on the bridge · If an IGMP response is seen on a given bridge port, then ...

17.01.2019 · hello, i finally got igmpproxy installed and my router settings are set to default. What settings need to be changed to allow multicast from WAN to LAN ? I read many posts on this topic but I can't get it to work. Please help. PC1(10.0.0.50) sends multicast stream (239.1.1.1:1234) to a switch and PC2 is connected over LAN to my router (192.168.1.1). Then I connected the WAN …

07.06.2018 · IGMP-Proxy If your client is behind NAT, it can't subscribe to multicast directly, so it needs some kind of proxy to do it for him. OpenWrt comes with igmpproxy utility to do that automatically. First you need to install package - opkg install igmpproxy You need to edit /etc/config/igmpproxy.conf according to your setup:

I know it is bit late, but i guess it will help someone who is still looking for answer. Install IGMPProxy install igmpproxy make menuconfig ...

【坑1】IGMP snooping和IGMP proxy IGMP snooping和IGMP proxy区别网上一大堆介绍，引用度娘文档一段： IGMP snooping 的实现机理是：交换机通过侦听主机向路由器的IGMP成员报告消息的方式，形成组成员和交换机接口的对应关系；交换机根据该对应关系将收到组播数据包只转给具有组成员的接口。

Jan 17, 2019 · hello, i finally got igmpproxy installed and my router settings are set to default. What settings need to be changed to allow multicast from WAN to LAN ? I read many posts on this topic but I can't get it to work. Please help. PC1(10.0.0.50) sends multicast stream (239.1.1.1:1234) to a switch and PC2 is connected over LAN to my router (192.168.1.1). Then I connected the WAN to the switch ...

15.09.2021 · IGMPproxy is a simple dynamic Multicast Routing Daemon using\\ only IGMP signalling (Internet Group Management Protocol).\\ \\ Installed size: 14kB Dependencies: libc, libssp Categories: network---routing-and-redirection Repositories: base Architectures:

29.09.2020 · 本帖最后由 ago 于 2020-9-10 23:09 编辑 硬件环境： 华为光猫+HC5962路由器+OPENWRT（大雕自编译版本） 拓扑图如下： 问题：我在接口-lan里面，打开IGMP Snooping监听功能，路由器就反复重启，关了就正常了。

Dec 19, 2021 · Learn about OpenWrt . Learn about OpenWrt. Supported devices ... IGMPproxy is a simple dynamic Multicast Routing Daemon using\\ only IGMP signalling (Internet Group ...

03.01.2013 · I thought I could use IGMP Snooping for this, since I found a comment "starting from 2.6.34, the kernel has IGMP snooping feature for the software bridges (disabled by default in OpenWrt)" and my kernel is 3.6.11 running r34761, but I can't find anywhere that explains how to turn this feature on.

Jan 18, 2019 · Instead the OpenWrt router must act as a router for multicast packets and igmpproxy does this by listening for and proxying the IGMP requests to the ISP as well, and then enabling forwarding of the UDP packets from WAN to LAN. OpenWrt has the package igmpproxy utility to do that.

26.02.2018 · I have 2 PCs which are linked by cables directly .PC1 address:10.10.10.1 , PC2 address:192.168.3.1 . Their firewalls have been shut down. PC1 is a stream server , sending multicast video to 239.1.1.1:1234 with VLC media player .PC2 could recieve and watch the video perfectly . Now I have a router between PC1 and PC2 . The router is running LEDE 17.01. …

Config igmpproxy to allow multicast udp from WAN to LAN · Installing and Using OpenWrt Network and Wireless Configuration.

The lines OpenWrt.lan > 224.0.0.1: igmp query v2 I believe indicates that your lan bridge has igmp snooping turned on and is acting as an ...

One of Openwrt and IPTV-igmpproxy One of Openwrt and IPTV-igmpproxy With IPTV installed, the equipment is a cable modem and an IPTV STB. The former turns HFC into ordinary Ethernet, and the latter is responsible for decoding and playing.

19.12.2021 · If you want to contribute to the OpenWrt wiki, please post HERE in the forum or ask on IRC for access. Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

Setup I have an Archer C7 V5 router with wan connected to fiber. I also have a TP link unmanaged switch with IGMP snooping connected to one ...

The igmpproxy adds routes and rules to the kernel which cause the kernel to forward these multicast UDP ...

Name: igmpproxy; Version: 0.2.1-4; Description: IGMPproxy is a simple dynamic Multicast Routing Daemon using\\ only IGMP signalling ...

running trunk on an x86 xen VM with igmpproxy and i've compiled in: IP_MULTICAST [=y] ... in over the wire (https://dev.openwrt.org/ticket/5299).

(The PIM must be a router - Layer 3.) :man_teacher: Welcome back to pimdb on the OpenWrt router.

Let me talk about igmpproxy first, as the name implies, realize the proxy of igmpproxy protocol~ This software is available in the official source of openwrt, you can install it directly, but the configuration is more particular.

15 # Put any debug or verbosity options into IGMP_OPTS. 16 # 17 # Examples: 18 # OPTIONS="-d -v -v" - debug mode and very verbose, this will land in. ... OpenWrt SVN ...

I try to configure my DM200 modem to make multicast working for ISP dedicated player box. I begin from stock configuration of OpenWRT 18.06.4 ...

18.01.2019 · Instead the OpenWrt router must act as a router for multicast packets and igmpproxy does this by listening for and proxying the IGMP requests to the ISP as well, and then enabling forwarding of the UDP packets from WAN to LAN . OpenWrt has the package igmpproxy utility to do that.

Jan 04, 2013 · I thought I could use IGMP Snooping for this, since I found a comment "starting from 2.6.34, the kernel has IGMP snooping feature for the software bridges (disabled by default in OpenWrt)" and my kernel is 3.6.11 running r34761, but I can't find anywhere that explains how to turn this feature on.