srch

19.08.2013 · The WAN accelerator in Veeam is highly optimized to reduce the data for links up to 100Mb. While it will work fine with faster links, you won't likely see a huge speed increase, but rather that the amount of data used is less. Of course, you can then scale this with multiple WAN accelerators, assuming you have the I/O to spare.

These are Source > Proxy > Network > Target, and each processing stage has a load monitoring counter associated with it.

Set up the source and target WAN optimization and see good speeds for the ... that Veeam is reporting the Target WAN as the bottleneck.

14.05.2015 · Bottleneck = Target WAN how to diagnose issue / fix. Got a question on how to check into this. I have a backup copy job going through wan accelerator. Client side is a 35 x5 cable connection, It's been uploading at approx 1.2 MB/s - 2.4 MB/s . MY side, 100 MB fiber connection, with usage on the circuit a pretty constant 20 - 30 MB/s.

Bottleneck source (VMware). NBD mode: 1. Storage read performance. 2. Host load. 3. Network connection between. VMware host and proxy. Veeam. Backup Server.

27.07.2016 · When I have the Veeam WAN accelerator enabled the EPL utilization drops to about 5-10%, the bottleneck becomes the target WAN, and the replication jobs take longer. If I turn off the WAN accelerator then the EPL utilization jumps to nearly 100%, the bottleneck becomes the network, and my replication jobs complete more quickly. What's going on here?

Only a data.veeamdrf file is located in the \VeeamWAN\GlobalCache\src folder. This file will be synchronized from the target WAN accelerator during the very ...

14.07.2017 · So I've been playing with the different setup and I guess the first backup is just very slow. Once the full backup is completed, the following incremental backup is much much faster. I also noticed that when the Proxy is the Veeam server, the …

09.04.2021 · Configuring Target WAN Accelerators To optimize VM traffic going to the Veeam Cloud Connect infrastructure during the backup copy and replication jobs, the SP and tenants can configure WAN accelerators on their sides. WAN accelerators in the Veeam Cloud Connect infrastructure must be configured in the following way:

I have a pretty new Veeam setup so trying to monitor its performance and so far, it been slow. My environment is quite small wit.

16.07.2015 · This means that your network throughtput is insufficient, and is presenting a bottleneck on the whole data processing conveyor. “Target” is the target (backup/replica storage) disk writer component . The percent busy number for target component shows percent of time that the target disk writer component spent writing the data to the storage.

I've a Veeam B&R 8.0.0.2030 installation on Hyper-v. I've configured different replication jobs between 2 sites with a total size of about 3 TB.

When configuring the WAN accelerator, not all configuration parameters affect both source and target WAN accelerators. In this section we will highlight what ...

B. Bottleneck statistics can show the following states: Source/Ptoxy/Network/Source WAN Accelerator/Target WAN Accelerator/Target; C. Bottleneck statistics ...